Flash files can help you to resolve different issues that you can face with your device like IMEI issues, software issues, boot loop issues, or the dead issue. You need to use a flash tool to install the flash file on your system. In this article, we have talked about the Micromax Q4002 flash file. We have mentioned all the steps that you will have to follow to install the Micromax Q4002 flash file. Read the article till the end to know more about it.
Before you can proceed with the flashing process, here are certain things that you need on your system. It is important that you have all the things and then you proceed with the process.
- You need to have some basic knowledge about the process. In case you are not aware, you can consult an expert before starting the process.
- Other than this, you need to charge your device completely so that it can operate till the end of the process. If not completely, it must be charged at least up to 70 percent.
- You will also have to create a backup of all your data present on the system. It is a must because post flashing all your data will vanish from your device. So, to save the data, you will have to create a backup.
- The next thing that you have to do is to make sure that you download the driver and the tool from the authenticated website. Also, you need to check whether the file is safe to use on the system or not.
Steps to Install Micromax Q4002 Flash File
Below we have mentioned all the steps that you will have to follow to install the Micromax Q4002 flash file using the SPD upgrade tool. Follow the steps in the same way as we have mentioned.
- First, you will have to download the SPD driver on your system. You will then have to click on the downloaded file to start the installation process. Follow the on-screen instructions to complete the installation process.
- After this, you will have to download the stock firmware file for your device on your system. You can find the firmware file on the internet. Now, you will have to extract the contents of the firmware folder.
- Now, you will have to download the SPD tool on your system. You can download it from the official website. You will then have to extract the contents of the SPD tool folder also.
- Once done, you will have to open the tool window and then you will have to look for the UpgradeDownload file and then you will have to click on it.
- It will open the tool window for you and you will have to then click on the load packet option.
- Now, you will have to redirect the tool to the location where you have stored your data. You will then have to click on the firmware file. It will be stored with a .pac extension.
- Once done, you will have to click on the open option and then you will have to click on the start download option. It will then start the flashing process.
- After the completion of the process, you will see an upgrade message on the screen.
- You can then disconnect the device and also, you will have to end the tool window.
Download Micromax Q4002 Stock Firmware Flash File
So, these were all the steps that you have to follow to install the Micromax Q4002 flash tool. We hope that following all the steps, in the same way, will help you to install the flash file. Hopefully, the article has helped you.